Baby Lock Ellageo BLL, Instruction And Reference Manual

Page: 26 / 212

LOWER/UPPER THREADING
G
etting
Re
ad
y
25
1
e
While holding the thread from the spool in
your right hand, hold the end of the thread
with your left hand, and then pass the thread
through the thread guide.
a
Thread guide
f
Pass the thread under the pin on the bobbin
winding pretension disk and guide, and then
pass it around the pretension disk.
* Make sure that the thread passes under the
pretension disk.
a
Pin
b
Pretension disk
g
Wind the thread clockwise around the bobbin
four or five times.
h
Pass the end of the thread through the guide
slit in the bobbin winder seat, and then pull
the thread to the right to cut it with the
cutter.
a
Guide slit
b
Bobbin winder seat
i
Slide the bobbin holder to the left until it
snaps into place.
* When the bobbin holder is set to the left, it works as
a switch to make the bobbin wind automatically.
a
Bobbin holder (switch)
→
The bobbin stops spinning automatically when it is
full, and the bobbin holder returns to its original
position.
Note
When using cross-wound thread on a thin spool, use
the small spool cap, and leave a small gap between
the cap and the thread spool.
a
Gap
b
Cross-wound thread
c
Spool cap (small)
a
b
c
a
a
b
Note
• Make sure that the thread between the spool and
the bobbin is pulled tight.
• Be sure to wind the thread clockwise around the
bobbin, otherwise the thread will become wrapped
around the bobbin winder shaft.
CAUTION
• Be sure to follow the process described. If the thread
is not cut with the cutter, and the bobbin is wound,
when the thread runs low, it may tangle around the
bobbin.
1
2
3
a
b
a