28 | www.BabyLock.com
Quilting with the Regalia ST
Preparing to Quilt
1. Make sure the machine has been cleaned, oiled, has a new needle, and that the
table is free from threads or other debris. If the machine isn’t already plugged in,
plug it in.
2. Wind one or more bobbins from the selected thread.
3. Turn on the main power switch at the back of the machine, and using the front
power button on the left side of the machine, turn the machine on or off as
needed.
4. Thread the needle and insert the bobbin. Set the bobbin and top tension.
5. After loading your quilt, use a 4" fabric scrap along the edge of the quilt backing
and batting to test the top tension. Make any adjustments to the tension as
needed.
To bring bobbin thread to the top of the quilt
1. Firmly holding the needle thread with your left hand, choose one of the following
methods to cycle the needle through one full rotation to bring the bobbin thread
to the top of the quilt.
A. Foot Pedal Method.
LIGHTLY
tap the foot pedal to make the needle go down.
Then
LIGHTLY
tap again to bring the needle up.
B. Needle Up/Down Button Half-Stitch. Find the Needle Up/Down Button in the
center of the color touchscreen main display. Press once to cycle the needle
down. Press again to cycle the needle back up.
C. Needle Up/Down Button, Full-Stitch. Find the Needle Up/Down Button in the
center of the color touchscreen main display. Press and hold briefly to cycle
the needle through one complete stitch cycle (down and back up).
2. Pull the fabric 3-4 inches away while holding the needle thread.
3. The bobbin thread will pull up to the top of the quilt. Grasp the loop and pull the
thread tail (loop) to the desired length.