![background image](http://html1.mh-extra.com/html/baby-lock/bl-j18-qm/bl-j18-qm_installation-manual_3233762050.webp)
Pg. 49
Step 6: LCD Installation
Parts Needed:
1- LCD Display
1- LCD Bracket
1- Plastic Knob
NOTE:
Before you proceed, disconnect the
ribbon cable that connects the handle bar to the
machine.
6-1 .
Using a 5mm Allen Wrench you will remove
the Jewel Handle Bar, by removing the two (2)
screw shown in Fig. 6-A.
6-2 .
Using the same 5mm Allen Wrench you
will remove the Jewel Handle Bar Key Block, by
removing the screw shown in Fig. 6-B.
6-3 .
Now, place your LCD Bracket on the
machine and then replace the Jewel Handle Bar
Key Block, being sure all three holes line up, as
shown in Fig. 6-C, using the same screw you
removed from the machine in step 3.
6-4 .
Reattach the Jewel Handle Bar, as shown
in Fig. 6-D, using the same screws you removed
from the machine in step 2.
6-5
. Slip the bolt on the back of the LCD through
the hole in your LCD Bracket and then secure it
using the plastic knob, as shown in Fig. 6-E.
6-6 .
Next, reconnect the handle bar ribbon cable
you disconnected at the beginning of this step.
Fig. 6-B
Fig. 6-A
Jewel Handle Bar
Jewel Handle
Bar Key
LCD Bracket
Fig. 6-C
Fig. 6-D
Fig. 6-E
LCD Display
Plastic Knob