![background image](http://html1.mh-extra.com/html/baby-lock/bl-j18-qm/bl-j18-qm_installation-manual_3233762029.webp)
Pg. 28
4-1 .
To install the Belt Brackets onto your Baby
Lock Jewel machine, you will first need to carefully
place the machine on its side. Looking at the
machine from the front (needle side), you will
lay it on its left side, exposing the rubber feet as
shown in Fig. 4-A.
4-2 .
If you have rubber feet on the bottom of
your machine remove all the feet by unscrewing
the flat-headed screw in the middle of each foot,
as shown in Fig. 4-A.
4-3 .
You will now install the Belt Bracket B. To do
this, first install a M6 x 30mm Phillips Head Screw
into the back hole (from the top of the machine),
as shown in Fig. 4-B.
4-4 .
Place the Plastic Spacer onto the screw.
4-5 .
Place the Belt Bracket B over this bolt and
over the other hole, as shown in Fig. 4-C. Use one
(1) #10 x 1/2” Hex Screw by placing it through
the other hole of the Belt Bracket B, as pictured,
and tighten the screw. Do not over tighten the
screw.
4-6 .
Using the included Allen wrench, tighten
the socket button head cap screw (with Plastic
Spacer), threading it through Belt Bracket B.
4-7 .
Install the Belt Bracket A where the two feet
used to be. Make sure the belt clamp attachment
is facing toward the front of the machine, as
shown (Fig. 4-D).
4-8 .
Secure this Belt Bracket A using the
remaining two (2) #10 x 1/2” Hex Screw,
tightening them completely as shown in Fig. 4-D.
Step 4: Belt Bracket to Sewing Machine
Parts Needed:
1- Belt Bracket A Assembly
1- Belt Bracket B Assembly
1- M6 x 30mm Phillips Head Screw
3- #10 x 1/2” Hex Screw
1- Plastic Spacer
Fig. 4-A
Fig. 4-B
M6 x 30mm Phillips
Head Screw
Plastic Spacer
Rubber Feet
Fig. 4-C
Belt Bracket B
front of machine
#10 x 1/2”
Hex Screw
Fig. 4-D
Belt Bracket A
#10 x 1/2”
Hex Screw