B.Pro B.PROTHERM BPT 820 E, Translation Of The Original Operating Instructions

Page: 9 / 36

B.PROTHERM stainless steel, unheated
– 5 –
Danger of children being trapped inside
Secure empty units from access by children. Children who climb into empty
units cannot free themselves if the unit door is locked from the outside. Place
the empty units with the unit door side toward the wall or place them in an
area inaccessible to children.
Change of location
Remove any objects from the unit top before changing its location. Objects
can slide off the unit top or the unit can tip over when pushed.
Hold unit door closed while changing its location. Gastronorm containers can
fall out of the unit when it is pushed.
To minimize the danger of damage to the castors, avoid overloading the
castors:

Do not move the unit when the castor brakes are locked

Avoid impacts

Do not traverse bumps or steps

Do not traverse uneven floors
The unit is to be pushed only, never pulled.
Always push the unit with two hands on the tube of the push handle.
Depending on the weight of the unit, if you push it with just one hand it is
possible you would not be able to apply the brakes quickly enough.
Be careful to ensure that your hands are not pinched (danger of crushing)
between the push handles and walls or other objects (e.g. cabinets).
Two people (one at each side wall of the unit) are required to move the unit
over ramps or recesses.
If the unit is on a slanted surface, it must be secured against rolling away with
further measures (e.g. wedges) in addition to locking the castor brakes.
The unit can be tilted to an angle of 10° when stationary before there is any
danger of it toppling. Only slanted surfaces with an incline of less than 10°
may be crossed.
Cleaning and care Hygiene
The provisions of the hygiene guidelines 93/43/EEC as well as your national
hygiene regulations must be complied with.
The inner unit body fulfils the requirements of the hygienic type H 1.
Cleaning frequency
Clean the unit thoroughly after each use.
Cleaning methods
Use only approved cleaning methods.
Do not use a steam jet unit or high-pressure cleaner.
Cleaning agent for synthetic parts
Do not use scouring agents. Scouring agents scratch the surface.
Do not use any of the following cleaning agents (damage to material!):

Ethyl alcohol, isopropyl alcohol and higher alcohols

Acetone

Cleaning benzene

Turpentine

Acetic ester