![background image](http://html1.mh-extra.com/html/b-k-lighting/brick-star/brick-star_installation-instructions_3119320003.webp)
RELEASED
6-8-15
REFERENCE
NUMBER
INS000022
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL ANYTHING IT MAY
DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
TECHNOLOGY
with
TECHNOLOGY
5/64” & 9/64” Allen Wrench
Small Flat Head Screw Driver
Phillips Screwdriver
Warning
Low Voltage
Hot Surface
LED BOARD / DRIVER / OPTICS
Architectural Recessed - Back Box
Standard Installation/Replacement
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION INSTRUCTIONS
Replacing LED Board/Driver and Optics
1. Remove fixture by loosening two (2) #10-24
fasteners. Gently pull away from installed back box
enough to expose back of faceplate.
2. Loosen two (2) Phillips head screws holding bracket
to faceplate. Remove bracket from faceplate to
expose optics and LED.
3. Space three fingers evenly around the optic and
gently rock optic to remove.
5. Disengage LED board and driver assembly. Replace
with new board and driver assembly.
6. Reverse install LED board and driver by carefully
re-engaging quick disconnects. Secure LED board
in place with stainless steel screws. Snap optics in
place.
7. With flat head screw driver rotate dial to desired
lumen output.
4. Use 5/64” Allen wrench to remove two (2) #2-56
socket head cap screws on LED board, grasp
LED board and gently pull up to expose quick
disconnect.
8. Attach bracket to faceplate by securing (2) Phillips
screws. Aim to desired position. Tighten two (2)
Phillips screws to lock in place when desired angle
is set.
9. Mount faceplate using two (2) #10-24 screws with
1/8” Allen wrench. Tighten evenly to compress
gasket. Do not over tighten.
TOOLS
NEEDED:
By Others