![background image](http://html1.mh-extra.com/html/b-k-lighting/brick-star/brick-star_installation-instructions_3119320002.webp)
RELEASE DATE
5-18-16
REFERENCE
NUMBER
INS001003
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
2. To aim, loosen the two (2) Phillips screws
attaching the adjustable bracket to the
faceplate. Aim to desired position. Tighten two
(2) Phillips screws to lock in place when desired
angle is set.
Phase 2 - Finish Installation of Fixture with Remote Transformer
Phase 1 - Rough In
Installation of Back box
2. Install Conduit (By Others) to be used with
this product.
5. Connect box to conduit and pull wires for
connections (See Wiring diagram).
Additional Info
• Please follow National and Local electrical codes for your area.
• Suitable for through wire.
• Suitable for installation into combustible materials.
• Rated for 90° C.
• Orientation of installed back box determines faceplate screw
orientation.
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
TECHNOLOGY
with
TECHNOLOGY
BACK BOX
Solid State LED
Installation Instructions
LINE
12V
Fixture
COM
Remote
Transformer
COM
WIRING DIAGRAM
LED - For use with 12VAC
remote
transformer or magnetic transformers only. B-K
Lighting cannot guarantee performance with
third party manufacturers’ transformers.
3. Mount faceplate using two (2) #10-24 screws with
1/8” Allen wrench. Tighten evenly to compress
gasket. Do not over tighten.
1. Make watertight connections from remote
transformer to LED leads using waterproof wire
connectors. (By Others)
See wiring diagram.
1. Remove canopy and/or fixture from MB2
housing. Ensure unused tapped holes are
plugged to maintain seal. Plugs are provided.
3. To prepare MB2 for mounting, align
mounting brackets on back of box. Brackets
can be aligned to vertical, horizontal or 45°
orientation. Secure with mounting screw
using screwdriver.
Install back box so that front face is flush
with finished wall or ceiling. Make sure
rectangular back box is plumb before
proceeding.
4. Mount MB2 box to surface using mounting
hardware (Provided) using the mounting
brackets attached to back of MB2 box.
Alternative mounting methods may
compromise integrity of MB2 against water
intrusion and will void warranty.
NOTE: Surface conduit is a common entrance
for water if not properly sealed. Seal
connector threads and conduit with a suitable
sealant (Teflon tape, adhesive, etc.). Sealing
the conduit after knockouts are removed is
required to maintain warranty.