MVP3 ATX
SYSTEM BOARD
AWARD BIOS SETUP
3-12
3.2.2
JUMPERS
A jumper is a set of two, three or more jumper pins which allows you to make different
system configuration by putting the plastic connector plug (mini-jumper) on it. The
jumper setting is necessary when installing different components onto the mainboard.
Please make sure all jumper settings are correct before you can installation the
mainboard into the PC system.
(A) JP1
Clear CMOS button
Pin #
Function
1 - 2
Normal Operation
2 - 3
Clear CMOS
Note: Improper BIOS setting may cause hang-up to the PC system, In case that
it be happened and you can not handle your PC system any more, you
can use JP1 to clear the system configuration information which is stored
in the CMOS memory and get the PC system back to normal status.. Due
to the VIA MVP3 chipset features, Clear the CMOS when the power is on
is recommended. Please refer to the following steps to clear the CMOS
1.
Open the system cabinet and leave the system power on.
2.
Move the mini-mumper to Pin2 and Pin3.
3.
Click on the Reset button to reboot the PC system to clear the CMOS.
4.
Return the mini-jumper to its normal position ( Pin1 and Pin2).
(B) JP2~ JP4, JP6~JP8: CPU frequency selection
(C) JP9~JP13: CPU Voltage selection
PCI
4
PC
I 3
PC
I 2
PC
I 1
AGP
BAT1
SYS. BIOS
CN4
CN5
USB
CN1 COM1
CN2 COM2
CN6 LPT1
DIMM 3
DIMM 2
DIMM 1
CN8 ATX PWR.
CN9 FDC.
CN13 IDE 1
CN12 IDE 2
CPU
SL
1
SL
2
SL
3
JP 2
JP 3
JP 4
JP
9
JP
1
0
JP
1
1
JP
1
2
JP
1
3
JP 6
JP 7
JP 8
