IP 200 User Manual
Page 11 of 72
Connection procedure:
1. Rotate the footstand, please refer to the Setup section for details.
2. Connect the phone to the network, insert the Ethernet cable into
the port labeled
and then insert the other end into the network;
3. Connect the LAN port
of the IP200 to your PC with Ethernet
RJ-45 cable.
4. Connect IP200 to a power source, insert the power supply
connector into the port labeled
and then plug it into the
power source.
5. Connect the headset into the port labeled
at the bottom of
the phone (optional).
2.4 Setup
1. Turn the phone upside down;
2. Push the footstand 60° to snap the two remaining pegs into place.
Please refer to the pictures below for the correct placement of the
footstand. Please refer to the figure as shown below.
2.5 Deployment Sample
The following diagram is one deployment sample for your information.
