Azbil SLPC1F, User Manual

Page: 40 / 86

4-8
Chapter 4. Monitoring
z Changing of data
Manipulation by numeric input → Enter the number and press the
[Return]
key.
z Setting of user-defined address
Optional data not in the table can be registered to user configuration addresses UF
1 to 8 in the table. Data can be read or written depending on the data type.
•
Setting method
(1) From the
[Option (O)]
pull-down menu, select
[Setup]
and then the
[Numeric
Monitor] tab.
(2)
Enter the address of the data to be displayed in accordance with the list of
all communication parameters in
Single Loop Controller Model C1M User’s
Manual for Installation and Configuration (CP-SP-1448E).
z Use of the command line
Data can be read or written or the mode can be switched by directly entering
communication commands on the command line.
Handling Precautions
•
Be careful when writing command types, addresses, or data since sending
a mistaken command may cause problems.
•
Single Loop Controller Model C1M User’s Manual for Installation and
Configuration
(CP-SP-1448E) (for information on communications
commands and data addresses)
•
The loader lock is enabled.
z Checking details of alarms
You can view alarm details on the alarm details screen when an alarm occurs.
• Click the icon.
Selecting [Option (O)]
→
[Alarm (A)] gives the same result.
• Details of currently occurring alarms are displayed.
Handling Precautions
•
This window displays the details of currently occurring alarms, and
cannot be used to reset the alarms. To reset alarms, follow the instructions
in troubleshooting.
z
About the numeric group monitor
The numeric group monitor can be used when “Use RS-485 converter” is selected
for
[Communication setup]
in the Environment setting screen.
Up to eight groups can be monitored.