AB-6682
8
Installation procedure: 20 mm to 95 mm long shaft
1) Remove the C-clip and take out the shaft clamp.
2) Attach the shaft clamp to the damper shaft, mount the
actuator to the clamp, and attach the C-clip to the shaft
clamp to fix the shaft clamp.
3) Mount the universal bracket with 2 M4 screws, and fix
the actuator.
Actuator with forward rotation (‘L’ side outward)
Figure 9. Installation of the actuator with forward rotation
to 20-95 mm long shaft
Actuator with reverse rotation (‘R’ side outward)
Figure 10. Installation of the actuator with reverse rotation
to 20-95 mm long shaft
Wiring
CAUTION
•
To prevent product damage, always disconnect
the power supply from the product before
performing installation and wiring.
•
This product is designed for 24 V AC power
supply voltage. Do not apply any other voltage
(e.g., 100 V AC, 200 V AC) to the product.
Connect the lead wires as follows:
∗
Lead
wire
number
(indicated on each wire insulation)
Figure 11. Lead wires connection
For details regarding wires connection, refer to
Installation
Manual of Intelligent Component Series for SAnet
Communication
(AB-6713).
Side ‘L’
Black
SAnet
⊥
∼
24 V AC
Model MY8045A2001
1* 2* 5*
Red White
Side ‘R’
