AB-7163
3
CAUTION
(2/2)
Connect the cables to the product power supply terminals with the terminal lugs or an equivalent method to assure
permanent connection.
To connect the wires to the screw terminals, use crimp terminal lugs with insulation.
Failure to do so might cause short circuit or electric shock.
Firmly tighten the terminal screws.
Insufficient tightening of the terminal screws might cause overheating or fire (or inaccurate measurement).
To connect the wires to the screwless push-in terminals, strip 8 mm of the wire insulation. If the strip length is longer
than the specified, the stripped part of the wires will be exposed, causing electric shock or short circuit between
adjacent terminals. If the length is shorter than the specified, the stripped part will not contact the connector.
Do not block the ventilation holes of this product. (Be sure to peel off the protective sheet after installation and wiring).
Doing so might cause fire or device failure.
After mounting the modules on DIN rail, push up the DIN rail holders of the modules to secure them on the DIN rail.
If the modules are not fixed with the DIN rail holder, they might drop from the DIN rail and get damaged.
If more than the rated power voltage is applied to the product, replace the product with new one for your safety.
Failure to do so might cause device failure or overheating.
Do not disassemble the product.
Doing so might cause electric shock or device failure.
Dispose of the used batteries in accordance with your local regulations. Do not throw them in fire or in general
garbage.
Doing so might cause burst or ignition.
Dispose of the product as industrial waste in accordance with your local regulations.
Do not reuse all or part of this product.
