AB-7163
13
Precautions for Use
Do not mount the product under the conditions of high temperature and humidity.
Do not drop the product.
For the wire replacement, be sure to turn off the power to the product. (Disconnect the wiring between the power supply and
the product power terminals.)
Before turning on the power, make sure that the wires are correctly connected.
Several tens of seconds are required for the product normal operation after the power is turned on. During this time, the red
LED “ERR1” (major failure) on the front lights up indicating major failure temporarily, but this does not indicate an error.
Do not connect wires to vacant terminals.
Leave at least 35 mm clearance between the top/bottom surfaces of the product and other devices.
Peel off the protective sheet on the top surface of the product before turning ON the power.
(See Figs. 10 and 12.)
Figure 12. Batter label and protective sheet
Protective sheet
Battery label
