Assembly
10
Fig 16-17
Angle bracket
8. Locate the extractor assembly (13), four Hex bolts (h) (short)
and two Hex bolts (i) (long). With assistance lift the extractor
assembly (13) over the supports (3-4), lower the assembly
down and insert the two upright supports (4) into the
extractor’s mounting brackets to either side of the assembly,
see figs 18-19.
NOTE: Make sure the angle brackets to the top of the tube
supports (3) are to the outside of the extractor assembly
(13), not tucked inside the housing.
NOTE: YOU WILL REQUIRE ASSISTANCE FOR
THE NEXT STEPS!
Fig 18-19
9. Insert four Hex bolts (h) through the extractor’s mounting
brackets and tighten. Line up the holes in the nearest tube
support angle bracket (3) with the threaded holes to the side
of the extractor’s housing and secure in place with two Hex
bolts (i). Securely tighten all fixings, see figs 20-21-22.
13
4
3
Mounting bracket
Threaded hole
Fig 20-21-22
i
h
10. Locate the collector assembly (12) and eight 5/16" Hex bolt
washers and nuts (k), see fig 23.
Fig 23
12
k
