Assembly
9
Fig 07-08
c
e
d
m
f
8
Fig 09-10
5. Repeat step 4 for the remaining wheel. Once complete, go
round and securely tight the fixing then turn the assembly over,
see fig 10.
Fig 11-12-13
6. Find the upright supports (4), the
tube support bars (3) and fourteen
Hex bolts (h) (short). Line up
the four holes in the two upright
supports with the threaded holes to the rear of the extractor
base. Screw the hex bolts down through the upright supports
into the base and lightly tighten, see fig 11-12-13.
7. Locate the tube support bars (3) and six Hex bolts (h).
Line up the two pre-drilled holes in the support bars angle
brackets with the holes to the sides of the base assembly,
secure in place with the Hex bolts (h), see fig 14-15-16-17.
4
Support base
Fig 14-15
h
3
Continues Over....
