Assembly
5
Threaded Rubber Feet
Locate the four ‘Rubber Feet’ (C), remove one nut from each
of the threaded feet and place aside. Slot each threaded foot
through the four pre-drilled holes to each corner of the units
base. Replace the nuts, stand the unit upright and adjust each
foot in turn until the machine is level, see fig 01-02.
Fig 01-02
C
Access Plate
Find the the linishers side ‘Access Plate’ (G) and the two
threaded butterfly knobs and washers (F). Position the plate
against the linisher main assembly and line up the two holes
with the wo threaded studs on the linisher. Secure the plate in
position with the threaded knobs and washers, see fig 03-04-05.
Fig 03-04-05
G
Continues over...
Fig A
Fig B
H
Euro plug adaptor 13A
Loosen the two screws on the Euro plug, open up and insert
the pinned plug into the adapter as shown. Close the cover and
tighten the screws.
WORK TABLE
NOT INCLUDED
