Compound Jig
14
1
Terminology of the Jig
Back
Right
Front
Up
Down
Left
Platen
Bar
Compound jig
These are the striations,
we call them sharpening lines
25mm
The ‘RED’ circles in figure (A) shows the positions of the
grub screws used to adjust the compound jig, to the side
of the frame. The ‘GREEN’ circles in figure (B) shows the
postion of the Hex head screws used to fix the compound
jig to the side of the linisher.
A
B
Grub screw A
Grub screw B
Grub screw C
Grub screw D
Setting the jig to the Platen
2
3
4
Setting the Jig
To adjust the compound Jig to the machine you need to set the guide jig bar
assembly to the zero position. Once done tighten the locking handle.
With the two 12mm bolts slightly undone you will be able to move the platen forwards or
backwards in position.
With the abrasive belt fitted move the platen so that the abrasive just touches the bar.
Undo the two 12mm
bolts half a turn
Platen
Bar
This one needs re-setting
as the gap is to large
This is correct with no
gap showing
Locking
handle
Set the guide jig to zero
