Assembly Instructions
11
Fig16
Fig 17
Fig 18
Dust extraction outlet
Flexible hose
Flexible hose
Rip Fence Assembly
Locate the rip fence (A), rip fence extension (B) with ‘T’
bolts, washers and clamping knobs, fence guide rail (C)
and two M8 x 50 bolts and nuts.
1) Insert the two M8 bolts into the pre-drilled holes to the
side of the main saw table and loosely screw on the nuts.
2) Remove the cover to the end of the fence guide rail (C)
by removing the two Phillips screws, place safely aside,
see fig 19.
3) Line up the first bolt head with the ‘T’ slot in the fence
guide rail and slide on the rail, repeat for the remaining
bolt, see figs 20-21.
Fig 19
Fig 20-21
4) Replace the cover to the end of the guide rail (C)
and secure with the Phillips screws you removed earlier.
Position the rail so it lines up with the edge of the saw
table and only finger tighten the nuts at this point,
see fig 22.
Fig 22
Continues Over....
End cover
C
C
M8X50 Bolt
‘T’ Slot
Summary of Contents for AC250CM
