Assembly Instructions
9
2) Locate the steel pin plate (A) , line up the pins with the
elongated slots in the extension table (B) and lower the
plate into the table, see fig 4. Locate the two lift and shift
Fig 04
Fig 05
handles and slot them through the two pre-drilled holes
in the extension table (B) and screw them into the
threaded holes in the steel pin plate (A). NOTE: Make
sure to leave sufficient clearance between the steel
plate and the table frame for the next step.
3) Position the extension table (B) against the sliding
table assembly. Line up the steel pin plate (A) with the ‘T’
slot to the end of the sliding table and slide on the exten-
sion table (B), see fig 05.
4) Position the extension table so it’s roughly centred to
the sliding table and tighten the two lift and shift handles
to lock the asssembly in position, see fig 6.
Fig 06
MAKE SURE THE SUPPORT CASTING WHEEL
RUNS SMOOTHLY ALONG THE EXTENSION RAIL!
A
B
B
Lift and shift handle
5) On top of the extension table there are two adjustment
caphead screws, using a straight edge adjust the screws
until both sliding and extension tables are level.
Fig 07-08
Caphead screw
Straight edge
Caphead screw
Sliding Table Fence
Locate the sliding table fence, loosen the angle bracket
clamp by undoing the butterfly knob (A), loosen the steel
pin by releasing the clamping handle beneath the fence,
see fig 9. Line up and push the steel pin into one of the
Fig 09
Continues Over....
Steel pin
Clamping handle
Sliding table fence
A
Summary of Contents for AC250CM
