Axis M1065-LW, User Manual

Page: 41 / 74

AXIS M1065-LW Network Camera
About events
About events
The event pages allow you to configure your product to perform actions when different events occur. For example, the product
can start a recording or send an email notification when motion is detected. The set of conditions that defines how and when
the action is triggered is called an action rule.
How to set up action rules
An action rule defines the conditions that must be met for the product to perform an action, for example record video or send an
email notification. If multiple conditions are defined, all of them must be met to trigger the action.
For more information about available triggers and actions, see About triggers on page 41 and About actions on page 42 .
To use more than one trigger for the action rule, select Additional conditions and click Add to add additional triggers. When using
additional conditions, all conditions must be met to trigger the action.
To prevent an action from being triggered repeatedly, a Wait at least time can be set. Enter the time in hours, minutes and seconds,
during which the trigger should be ignored before the action rule can be activated again.
The recording Duration of some actions can be set to include time immediately before and after the event. Select Pre-trigger time
and/or Post-trigger time and enter the number of seconds. When While the rule is active is enabled and the action is triggered
again during the post-trigger time, the recording time will be extended with another post-trigger time period.
For more information, see the online help .
About triggers
Available action rule triggers and conditions include:
• Applications – Use installed applications to trigger the rule. See About applications on page 34 .
• Detectors
- Audio Detection – Trigger the rule when audio is detected. See Audio Detection on page 33 .
- Day/Night Mode – Trigger the rule when the product switches between day mode (IR cut filter on) and night
mode (IR cut filter off). This can for example be used to control an external infrared (IR) light connected
to an output port.
- Live Stream Accessed – Trigger the rule when any stream is accessed and during edge storage playback.
This can for example be used to send notifications.
- PIR – Trigger the rule when the PIR sensor detects motion. See PIR Sensor on page 33 .
- Tampering – Trigger the rule when tampering is detected. See About camera tampering on page 31 .
• Hardware
- Network – Trigger the rule if network connection is lost or restored. This can for example be used to start
recording to the SD card.
- Temperature – Trigger the rule if the temperature falls outside or inside the operating range of the product. This
can for example be used to send maintenance notifications.
• Input Signal
- Manual Trigger – Trigger the rule using the Manual Trigger button in the Live View page. See About the
controls in the live view window on page 11 . This can for example be used to validate actions during product
installation and configuration.
41