Axis M1065-LW, User Manual

Page: 42 / 74

AXIS M1065-LW Network Camera
About events
- Virtual Inputs – can be used by a VMS (Video Management System) to trigger actions. Virtual inputs can, for
example, be connected to buttons in the VMS user interface.
• PTZ
- Moving – Trigger the rule when the camera view moves due to a PTZ operation. This can for example be used
as an additional condition to prevent an action rule triggered by motion detection to record video while the
camera view moves due to a PTZ operation.
- Preset Reached – Trigger the rule when the camera stops at a preset position. This can be for example be used
with the Send Images action to upload images from the preset position.
• Storage
- Disruption – Trigger the rule if storage problems are detected, for example if the storage device is unavailable,
removed, full, locked or if other read or write problems occur. This can for example be used to send maintenance
notifications.
- Recording – Triggers the rule when the Axis product records to the storage device. The recording status trigger
can be used to notify the operator, for example by flashing LED lights, if the product has started or stopped to
record to the storage device. Note that, this trigger can be used only for edge storage recording status.
• System
- System Ready – Trigger the rule when the product has been started and all services are running. This can for
example be used to send a notification when the product restarts.
• Time
- Recurrence – Trigger the rule periodically. See How to set up recurrences on page 44 . This can for example be
used to upload an image every 5 minutes.
- Use Schedule – Trigger the rule according to the selected schedule. See How to create schedules on page 44 .
About actions
Available actions include:
• IR Illumination – Activate or deactivate IR light.
• Day/Night Vision Mode – Set day mode (IR cut filter on) or night mode (IR cut filter off).
• Overlay Text – Display an overlay text. See How to include overlay text in an action rule on page 24 .
• Play Audio Clip – See Audio Clips on page 26 .
• PTZ Control
- Preset Position – Go to a preset position.
- Guard Tour – Start a guard tour. See About guard tours on page 29 .
• Record Video – Record video and audio to a selected storage. To record audio, use AAC audio encoding and make sure that
audio is enabled in the selected stream profile.
• Send Images – Send images to a recipient.
• Send Notification – Send a notification message to a recipient.
• Send SNMP Trap – Send an SNMP trap message to the operator. Make sure that SNMP is enabled and configured
under System Options > Network > SNMP .
• Send Video Clip – Send a video clip to a recipient.
42