AXIS M1065-LW Network Camera
Video and Audio
Audio Input
Configure the audio input settings under
Audio
>
Audio Settings
.
Source
lists the built-in microphone.
Use the
Input gain
to control the volume (dB Full Scale) of the audio input. If the sound is too low, choose a higher dB, to amplify
the sound. If the sound is too high, choose a lower dB. The
Level
bar gives a visual representation of the audio signal level in dB
relative to the full-scale input level.
•
Green – the signal is at a good level.
•
Yellow – the signal is becoming distorted.
•
Red – the signal is distorted.
Use the
Encoding
option to select digital audio encoding format.
•
AAC
is used for encoding only in the Axis product. For decoding, no license is included in the Axis product.
•
G711
is an unlicensed standard codec that is useful when integrating audio into a VoIP system
•
G726
is an unlicensed speech codec that is most commonly used within the security industry.
The
Sample rate
defines the number of times per second the sound is sampled. A higher sample rate will provide better audio
quality, but also requires a greater bandwidth.
Set the required
Bit rate
depending on the selected encoding. A higher bit rate will give better audio quality. A lower bit rate
may have latency or delay, but will require less bandwidth.
For more information about these settings, please see the online help
.
Audio Output
Configure the audio output settings under
Video & Audio
>
Audio Settings
.
Output gain -
Control the volume of the line audio output. If the sound is too low, choose a higher dB value. If the sound is
too high, choose a lower dB value.
Audio Clips
An audio clip is a sound file that can be played when events occur or directly from the
Live View
page. The audio clip must first be
uploaded to the Axis product or recorded by a microphone connected to the product.
To add, download, modify or remove audio clips, go to
Video & Audio > Audio Clips
. For more information see the online help
.
To configure the Axis product to play audio clips when an event occurs, an action rule must be set up. For more information,
see
.
Note
Audio clips cannot be used if the product’s audio functionality is enabled. The audio functionality is enabled on the
Audio
tab under
Video & Audio > Video Stream
.
26
