Management and Configuration
AXIS 5900 User’s Manual
117
Accessing the Print
Server’s Web Pages
over https://
Whenever SSL/TLS is enabled, you can only reach the print server’s Web
interface through the secure services. The unsecure way via http:// is
closed and now you have to address the print server’s Web interface in
the secure way, i.e. via https://.
Disabling Insecure
Protocols
To further increase security, you must disable protocols that are
considered insecure;
•
FTP (used by AXIS ThinWizard. If FTP is disabled, AXIS ThinWizard can
not function properly.)
•
Telnet
•
Auto-IP
•
DHCP
•
BOOTP
•
Remote Config (used by AXIS NetPilot)
•
SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP
is disabled, AXIS ThinWizard can not function properly.)
To disable these protocols, go to
Admin | Security Settings | Protocol
Settings | Detailed View
and mark the check boxes. Click
OK
to finish.
Only enabled protocols will be visible from this view!
To enable these protocols, select
Admin | Network Settings | Detailed
View | TCP/IP Network
for FTP, Telnet, AutoIP, DHCP and BOOTP.
Remote Config is enabled via
Admin | General Settings | RConfig
Support
.
Important:
To ensure maximum security, it is highly recommended that you change
your Administrator password after generating a certificate and disabling
insecure protocols! This is done from
Admin | General Settings | Change
=> | General | Root Password
.
Checking
SSL/TLS Status
To check SSL/TLS status, open the print server’s Web interface and select
Admin
|
Network Settings
|
Detailed View
|
TCP/IP Network
to see if the
HTTPS Enabled
parameter is set to Yes or No.
To View a Certificate
To view a Certificate, open the print server’s Web interface, select
Admin
|
Security Settings
and click
View
next to the Certificate.
To Delete a Certificate
To delete a Certificate, open the print server’s Web interface, select
Admin
|
Security Settings
and click
Delete
next to the Certificate.
