SBC856A1 Series All-in-One POS Board User’s Manual
58
Serial ATA Setup Information
A p p e n d i x A
Serial ATA Setup Information
The board provides the last technology IDE connector. The two slim
type connector of Serial ATA are for fast IDE data transfer. Nowadays
the Serial ATA can provide the data transfer rate up to 150MB/sec. This
is better than the traditional Parallel ATA (Ultra ATA/133) interface for
133MB/sec.
On-Chip Serial ATA configuration:
This option is to setup the Serial ATA work with the modes below:
z
OnChip SATA
The choice: Enabled, Disabled.
z
SATA Mode
IDE Mode
: On-Chip Serial ATA configuration.
z
OnChip IDE Channel0
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Select
Enabled
to activate each channel separately.
NOTE:
1. S-ATA (0) support install Win2K & WinXP infirt channel.
2. S-ATA (0,1) can be a Device under WinNT, Win2K, WinXP.
3. Win98 & WinME install should be disable S-ATA (Fix ACPI Enable Stanby
can’t use)
