Axiom SBC8156, User Manual

Page: 86 / 96

SBC8156 Pentium All-in-One CPU Card Series User’s Manual
Award BIOS Reference ,*
DISK BOOT FAILURE, INSERT
SYSTEM DISK AND PRESS ENTER No boot device was found. This could
mean that either a boot drive was not
detected or the drive does not contain
proper system boot files. Insert a system
disk into Drive A: and press <Enter>. If
you assumed the system would boot from
the hard drive, make sure the controller is
inserted correctly and all cables are
properly attached. Also be sure the disk
is formatted as a boot device. Then
reboot the system.
DISKETTE DRIVES OR TYPES
MISMATCH ERROR - RUN SETUP
Type of diskette drive installed in the
system is different from the CMOS
definition. Run Setup to reconfigure the
drive type correctly.
DISPLAY SWITCH IS SET
INCORRECTLY
Display switch on the motherboard can be
set to either monochrome or color. This
indicates the switch is set to a different
setting than indicated in Setup. Determine
which setting is correct, and then either
turn off the system and change the
jumper, or enter Setup and change the
VIDEO selection.
DISPLAY TYPE HAS CHANGED
SINCE LAST BOOT
Since last powering off the system, the
display adapter has been changed. You
must configure the system for the new
display type.
EISA Configuration Checksum
Error
PLEASE RUN EISA
CONFIGURATION UTILITY
The EISA non-volatile RAM checksum is
incorrect or cannot correctly read the
EISA slot. This can indicate either the
EISA non-volatile memory has become
corrupt or the slot has been configured
incorrectly. Also be sure the card is
installed firmly in the slot.
Continued . . . . .