SYSTEM OPERATION
Apply control power to unit. Place breakers in the AXI International Smart Filtration Controller in the “ON”
position.
Automatic:
Place the key switch in the “AUTO” position. When the timer contacts close, the solenoid will open until
the timer setting has expired.
Manual (Override):
Place the key switch in the “RUN” position. The solenoid will open until the switch is returned to the “OFF”
or “AUTO” mode positions or till an alarm or overload has been tripped.
PROGRAMMING THE TIMER
The programmable timer is part of the Micro PLC settings of the AXI International Smart Filtration
Controller located inside the STS 6000 system.
Note: The PLC uses military time – all times programmed must be in that format.
1. Please make sure the Emergency Stop button is not engaged, the key switch set to “OFF” and
push the “ALARM RESET” button on the control panel.
2. When power is first applied to the system the display of the PLC will show (blinking) date and time.
3. We will now
set current date and time
(must be in military format):
4. Hit the “ESC” button
5. Select
‘Stop’
and press “OK”
6. Select
‘Yes’
(use down arrow key) and press “OK”
7. Select
‘Setup’
(use down arrow key)and press “OK”
8. Select
‘Clock’
and press “OK”
9. Select
‘Set Clock’
and press “OK”
10. Using the arrow keys set current day of the week, time and date as indicated in the display and
press “OK”
( or to change value, or to change between week day, time and date).
11. When finished entering press “OK” to confirm
12. Press “ESC”
13. Select
‘Start’
and press “OK” – correct time and date should be displayed
14. We are now ready to
program the timer
(military time format must be used):
15. Hit the “ESC” button
16. Select
‘Set Param’
(use down arrow key) and press “OK”
17. Push down arrow key till
‘Timer 1’
is displayed
18. Press “OK”
19. Use left and right arrow keys to select the day/days of the week the system should
automatically turn on and the up or down arrow key to activate the selected day.
20. Use arrow keys in same manner to program the
‘On’
time – when the system will switch on (on
the selected day/days)
21. Use arrow keys in same manner to program the
‘Off’
time – when the system will switch off (on
the selected day/days)
22. Press “OK” to confirm entry when finished
23. If required you can set up to 3 Timers by using the up and down arrow key
