GENERAL DESCRIPTION
ENG
Page 30
14.3 DISPLAY DESCRIPTION
1. ON AIR Preset: shows the current processing curve. The presets ranging from 1 to 30 are factory
preset, while curves 31 to 40 are user settable. A table showing the curve parameter levels is
available on this manual.
2. AGC
level: shows the gain factor that the processor applies to the input signal. The best AGC
values range close to 0 dB (or, still better, are slightly negative: - 1, - 2, etc).
3. Low frequencies compression factor (30Hz-200Hz band). Shows the compression factor (range 0
to -12dB) applied to the lower frequencies: the higher the meter bar is, the stronger is the
compression and therefore the presence of this component in the final signal is lower. The
compression threshold level depends on the selected curve.
4. Medium frequencies compression factor (I band: 200Hz-1.5KHz) shows the compression factor
(range 0 to -12dB) applied to the medium frequencies (band I): the higher the meter bar is, the
stronger is the compression and therefore the presence of this component in the final signal is lower.
The compression threshold level depends on the selected curve.
5. Medium frequencies compression factor (II band: 1.5kHz-4.8kHz) shows the compression factor
(range 0 to -12dB) applied to the medium frequencies (band II): the higher the meter bar is, the
stronger is the compression and therefore the presence of this component in the final signal is lower.
The compression threshold level depends on the selected curve.
6. Medium frequencies compression factor (III band: 4.8kHz-9kHz) shows the compression factor
(range 0 to -12dB) applied to the medium frequencies (band III): the higher the meter bar is, the
stronger is the compression and therefore the presence of this component in the final signal is lower.
The compression threshold level depends on the selected curve.
7. High frequencies compression factor: (9.5Khz-15KHz band) shows the compression factor (range
0 to -12dB) applied to the higher frequencies: the higher the meter bar is, the stronger is the
compression and therefore the presence of this component in the final signal is lower. The
compression threshold level depends on the selected curve.
8. Operating level of HF Limiter (a limiter in 6 – 15 kHz band which acts on the processed signal).
9. Left audio channel input level (after AGC system). Range: 0 to -40dB
10. Right audio channel input level (after AGC system). Range: 0 to -40dB
Summary of Contents for Falcon 35
Page 2: ......
