Page | 16
RIGHT MOTOR MOUNT (when you face the house):
If the awning stops from closing completely:
1.
Identify the
White Limit Control
(away from the wall)
2.
If the awning stops from retracting completely, then turn the limit control “CLOCK WISE” direction (one
turn at a time) unit tit retracts completely.
If the motor continues to turn even after the awing completely retracted then do the following:
1.
Identify the
White Limit Control
(away from the wall)
2.
Stop by pressing the stop button
3.
Extend the awning about two feet and then
4.
Then turn the control “COUNTER CLOCK WISE” (three full turns) and turn push the button to retract if the
awning still continues to retract more than repeat the steps until it is completely adjusted.
If the awning doesn’t extend fully or to your desired extension then do the following:
1.
Identify the
Red Limit Control
(close to the wall)
2.
If the awning doesn’t extend fully or to your derided extension, then turn the red limit control “CLOCK
WISE” unit it opens completely or it reaches till your desired extension
If the awning continues to extend beyond your desired extension, then do the following:
1.
Stop by pressing “STOP” button
2.
Retract the awning by pressing “retract” button for about two to three complete turns and press “STOP”
to stop it from further retracting
3.
Turn the
RED Limit Control
“COUNTER CLOCK WISE”
4.
Press to extend, if it extends still too much then
5.
Repeat
the above steps until it reaches your desired extension.
You can always use extend and retract manually by pressing the controls on your remote control.
REPLACING THE VALANCE
Remove the right and left front end caps
Using the providing allen wrench, unloosen all the bullets at the ends of the fabric
Remove the bullets from the C-channel
Remove the valance by pulling on it from the right side
Reinstall the new valance by sliding the top bead into the same slots in the front bar
Reinstall both bullets and tighten the allen screws
Reinstall the right and left front end caps
