4
CAMERA PARAMETERS
NOTE:
The method below is available only when the camera is used with our brand’s HD CCTV DVR.
On the DVR live view, right click to show the DVR main menu, and select “ADVANCED CONFIG”
“DCCS”. Then, select the channel which connects this camera, and click “SETUP” to enter the menu of
camera parameters.
ADVANCED CONFIG
CAMERA
CH1 CH2 CH3 CH4
DETECTION
MENU SETUP
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
F.W. 1016
DCCS
DEVICE AVTXXX
NOTIFY
CONNECTION OK
EXIT
Item
Description
BRIGHTNESS
Click the current value to manually adjust the brightness of the image. The higher the value,
the brighter the image.
CONTRAST
Click the current value to manually adjust the contrast of the image. The higher the value,
the higher the contrast ratio.
HUE
Click the current value to manually adjust the hue of the image.
SATURATION
Click the current value to manually adjust the saturation of the image. The higher the value,
the more saturated the image.
CAMERA GUARD
Enable “GUARD LOCK” to temporarily disable the pan function of this camera and fix the
camera surveillance area.
For details, please refer to the section “CAMERA GUARD”.
CRUISE MODE
Select the cruise mode when the
is selected in the PTZ mode. There are three
options: AUTO PAN, SEQUENCE and CRUISE.
AUTO PAN – Pan within the range specified in
CRUISE CONFIG
.
SEQUENCE – Patrol based on the sequence group specified in
CRUISE CONFIG
.
CRUISE – Patrol based on the route recorded in
CRUISE CONFIG
.
CRUISE CONFIG
The setting shown here depends on what you selected in
CRUISE MODE
:
AUTO PAN – Specify the range for auto pan to run.
For details, please refer to the section “AUTO PAN SETUP”.
SEQUENCE – Configure a sequence group for area patrol.
For details, please refer to the section “SEQUENCE SETUP”.
CRUISE – Customize the patrol route in 200 seconds.
For details, please refer to the section “CRUISE SETUP”.
AUTO TRACKING
Set the surveillance area for auto tracking, and the tracking timeout.
For details, please refer to the section “AUTO TRACKING SETUP”.
DISPLAY ZOOM RATIO
Select “ON” to show the zoom ratio on the live view.
ENABLE TILT LIMIT
When this function is set to “OFF”, the tilt angle is just as the specifications said, but it has
the possibility to see a little bit edge of the lens shield during camera tilting.
When this function is set to ”ON”, the tilt angle is slightly smaller than what’s said in the
specifications, but no lens shield edge is seen during camera tilting.
PAN SPEED
Set the speed for pan movement.
TILT SPEED
Set the speed for tilt movement.
VIDEO FORMAT
Select the video format: NTSC / PAL.
