2
PACKAGE CONTENT
Camera
User manual
Bracket (w/carabiner)
INSTALLATION
Step1: Loosen the screws on the dome cover to remove it (as shown in
Figure 1
), and take all EPE foam rolls off in the
camera.
NOTE:
When you remove the EPE foam rolls, please be careful not to damage the inner mechanism
of the camera.
Then, replace the cover back.
NOTE:
Make sure the dome cover is clean without fingerprints before replacing it back.
Step2: Pass the cables to be connected through the bracket, and fasten the bracket to the wall (ash shown in
Figure 2
).
Figure 1
Figure 2
Step3: Hook the camera and the bracket together with the supplied carabiner, and connect the cables. Then, pull the
cables from the other side of the bracket to hide the connectors in the bracket (as shown in
Figure 3
).
Step4: Insert the camera to the bracket, and roate the camera a little bit to hook it. Then, use a wretch to fasten the
screws on the two sides of the bracket to secure the connection (as shown in
Figure 4
).
Figure 3
Figure 4
