The actual daughterboard and DUT are shown below, configured for 10 mA of input
bias current (with R3 = 348 Ohms and the A23 battery installed):
Top side
Bottom side
With the daughterboard installed in the ZIF socket in the negative position (silkscreen
arrows pointing same direction, daughterboard is as far as possible from the ZIF lever),
and AMP1 set to -1.5 kV and AMP2 set to +32V, these waveforms were obtained:
48
Summary of Contents for AVRQ-5-B
