Page 3
FEATURES OVERVIEW
The following features are programmable for each individual channel. For instructions on how to program each feature
refer to the page number reference.
Feature
Description
Page
Adding new remotes &
deleting remotes
Up to 5 remote controls can be programmed in.
3
Latched
: activating the channel activates the output, activating the channel
again deactivates the output eg. if a light was connected to the output, pressing
the button once would turn the light on, pressing the button again would turn
the light off.
Latched or pulsed output
(factory setting is a 1-
second pulsed output)
Pulsed:
activating the channel will activate the output for only 1 second eg. if a
light was connected to the output, pressing the button would turn the light on
for 1-second, the light will then turn off.
4
Normally open:
output switches to closed when the channel is activated.
Normally open or
normally closed outputs
Normally closed:
output switches to open when the channel is activated eg. use
on channel 4 when a normally closed circuit is required. Channels 1, 2, and 3
have connections for both normally open and normally closed outputs.
4
Timed output
Output will activate only for a programmed time when the channel is activated
eg. if a light was connected to the output, pressing the button would turn the
light on for the programmed time, the light will then turn off.
5
Momentary output
enable
Output is activated while button on remote control is held down and deactivates
when button is released. eg. if a light was connected to the output, while
pressing the button the light would be on, releasing the button will turn the
light off.
6
Adding wireless devices
Allows wireless detectors to be learnt into the system to trigger one of the
output channels eg. use this for learning in wireless detectors
7
Reed mode enable
Output is activated on open and deactivated on close of wireless reed switch.
Use when using wireless reed switches,
8
Low Battery output from
wireless devices
Output is activated when a wireless detector learnt into any channel transmits a
low battery signal. i.e. When the battery in the wireless detector goes low, the
output will activate.
8
Re-setting the AVS RXPRO
Re-setting erases all remotes and detectors and returns programming settings to
the factory default.
9
AVS remote conversion
Using other AVS remotes with the AVS RXPRO
9
ENTERING PROGRAMMING MODE
1.
Disconnect 12VDC power from the unit.
2.
Press and hold button 2 on the remote control.
3.
Reconnect 12VDC Power to the unit.
4.
Release button 2 once the display lights stop scrolling. You are now in
programming mode.
