Page 8
ADDING WIRELESS DEVICES
(wireless PIR, reed switch, smoke detector, emergency pendant)
1.
Enter programming mode (see page 3)
2.
Press button 3 repeatedly until the channels lights indicate the
output channel you wish to program.
Select the channel that you wish to be activated by the
detector.
3.
Press button 2 repeatedly until the feature lights are on as
shown.
4.
Press button 1 to set the feature light(s) to not flashing.
Note:
By default the feature light(s) will be flashing, if not do
not press button 1.
5.
Press button 2 repeatedly until the feature lights are off as
shown.
6.
Press and hold button 1 until the channel light(s) begin to flash.
7.
Now trigger the new detector; the channel light(s) should stop
flashing.
Note
: detectors are high-powered and should be triggered at
least 5 metres away from the unit.
8.
Press and hold button 2 on the remote control until the lights
start scrolling - The detector has now been learnt in.
Note:
if using a wireless reed switch also follow
Reed Mode
Enable
on the next page.
