Avocent SPC 800, Installation & User Manual

Page: 10 / 52

4
SPC Installer/User Guide
For configurations that require multiple fully-privileged users, administrative
privileges may be granted to other users in the system.
Automatic time-out
When an SPC user ends a session, configuration changes made during the
session are saved. For added system security, a user session will be terminated
automatically after five minutes of inactivity, without saving any configuration
changes made during the session. If a user is called away unexpectedly, an
unprotected channel will not remain open indefinitely.
Configuration reset capability
The SPC may be reset to the factory default configuration through an
administrative level command. If the administrator password is lost or
unavailable, the unit may be reset manually by pressing a reset button on the
SPC unit.
Safety Precautions
This section contains important safety and regulatory compliance information that
should be reviewed before installing and using the SPC. For input and output
current ratings, see
Appendix B .
• This equipment is only for installation and use in a Restricted Access
Location with the following installation and use instructions.
• This equipment is designed to be installed on a dedicated circuit.
• The dedicated circuit must have circuit breaker or fuse protection. SPC
units have been designed without a master circuit breaker or fuse to avoid
becoming a single point of failure. It is the customer’s responsibility to
provide adequate protection for the dedicated power circuit. Protection
should not exceed 120% of the Total Output Rating of the SPC units (see
Appendix B ) and must meet all applicable local, state and federal codes
and regulations.
• The plug on the power supply cord shall be installed near the equipment
and shall be easily accessible.
• Installation Orientation: SPC units are designed to be installed in a
vertical orientation.
• Always disconnect the power supply cord before opening to avoid
electrical shock.