Avocent Cyclades ACS, Installation/Administration/User Manual

Page: 31 / 212

Chapter 2: Installation 15
I
Figure 2.1: Placement of Mounting Brackets (Forward Mounting Configuration Shown)
• You will need a hex screwdriver and the nuts and bolts provided with the mounting brackets to
perform the following procedure.
To rack mount the console server:
1. Install the brackets on to the front or back edges of the ACS console server using a screw
driver and the screws provided with the mounting kit.
2. Mount the console server unit in a secure position.
Making an Ethernet connection
Connect a CAT5 patch cable from the console server port labeled 10/100Base-T to an Ethernet hub
or switch.
To connect devices to serial ports:
Using patch cables with RJ-45 connectors and DB-9 console adaptors assemble crossover cables to
connect the console server serial ports to the device’s console port.
NOTE: For ACS16 and ACS32 models with single or dual DC power supplies, make sure you use shielded
cables when connecting devices to the serial ports. Shielded cables are required to comply with NEBS Level 3
certification on these models.
Making a direct connection to configure the network parameters.
On your Windows workstation, ensure that a terminal emulation program is installed. On servers
running a UNIX-based operating system such as Solaris or Linux, make sure that a compatible
terminal emulator such as Kermit or Minicom is installed.
To connect to the console port:
You can use a CAT5 straight-through cable with RJ-45 connectors and the appropriate adaptor
provided in the product box to assemble a console cable. All adaptors have an RJ-45 connector on
one end and either a DB25 or DB9 male or female connector on the other end.
1. Connect the RJ-45 end of the cable to the port labeled Console on the console server.
2. Connect the adaptor end of the cable to the console port of your server or device.
Brackets