MSC C10M-BT / MSC C10M-BTC
User Manual
31 / 90
2.12.16 Module Type Definition
Signal
Pin
Type
Signal
Level
Power
Rail
Remark /
Tolerance
PU/PD/SR Description
Source / Target
TYPE10#
O
47k pull
down
COM.0 Rev
2.1 Module
Type 10
ePD = 47
KΩ
Dual use pin. Indicates to the Carrier Board that a Type 10 Module is
installed. Indicates to the Carrier that a Rev 1.0/2.0 Module is installed
TYPE10#
NC Pin-out R2.0
PD Pin-out Type 10 pull down to ground with 4.7K resistor
12V Pin-out R1.0
This pin is reclaimed from the VCC_12V pool. In R1.0 Modules this pin
will connect to other VCC_12V pins. In R2.0 this pin is defined as a no
connect for types 1-6. A Carrier can detect a R1.0 Module by the
presence of 12V on this pin. R2.0 Module types 1-6 will no connect this
pin. Type 10 Modules shall pull this pin to ground through a 47K
resistor.
Carrier board logic
2.12.17 Power and GND
Signal
Pin
Type
Signal
Level
Power
Rail
Remark /
Tolerance
PU/PD/SR
Description
Source / Target
VCC_12V
Power
12V (±5%)
Primary power input: +12V (±5%)
Wide input range 4.75V
– 20.0V
Voltage
Regulators
VCC_5V_SBY
Power
5V (±5%)
Standby power input: +5.0V (±5%)
If VCC5_SBY is used, all available VCC_5V_SBY pins on the
connector(s) shall be used.
Only used for standby and suspend functions.
May be left unconnected if these functions are not used in the
system design.
VCC3.3V SUS
regulator
VCC_RTC
Power
Real-time clock circuit-power input : +3.0V (+2.5V to +3.3V)
BT SOC
GND
Power
Ground - DC power and signal and AC signal return path. All
available GND connector pins shall be used and tied to Carrier
Board GND plane.
