MSC C10M-BT / MSC C10M-BTC
User Manual
15 / 90
Power Supply
+12V primary power supply input
+5V standby
Option, is not required for module operation.
If not present, customer must ensure that the supply voltages which are generated on the
carrier board are switched off during suspend states, so that no current from the carrier
board’s signal lines can flow to the CPU board.
3.3V RTC power supply
Option, is not required for module operation.
BIOS SETUP data is stored in a nonvolatile backup memory device, therefore configuration
data will not get lost after power removal (except for time and date information)
Voltage
Input range
Power Consumption
+12V
+4.75V
– 20.0 V
Refer to chapter 2.6
+5V Standby
+4.75V
–
5.25 V
+3V RTC power supply
+2.5V
– 3.3V
< 4 µA
Power Dissipation
2.6.1 Running Mode
All measurements were made by plugging the MSC C10M-BT module onto a
MSC C10-MB-
EVA
carrier. The modules were equipped with various memory quantities. The table below
shows typical values which refer to consumption of the module itself without consumption of
the base board and CPU fan.
The following applications have been tested.
1. DOS prompt.
2. Windows desktop (idle) under Microsoft Windows 7 Professional 64-bit SP1.
3. Running test tool to achieve 100% CPU workload on each processor core/thread and
Graphics workload under Microsoft Windows 7 Professional 64-bit SP1.
Module / CPU
DOS
Win 7 Idle
Thermnow Test tool
long term
max.
1)
C10M-BT-3311 (Intel® Atom
TM
E3815, single
core, 512 KB cache, 1.46GHz, 5W, 1ch DDR3L
)
2GB ECC
3.0 W
2.9 W
6.2 W
6.9 W
C10M-BT-3324 (Intel® Atom
TM
E3827, dual core,
1 MB cache, 1.75GHz, 8W, 2ch DDR3L)
4GB ECC
3.7 W
3.4 W
7.3 W
10.5 W
C10M-BT-33E5 (Intel® Atom
TM
E3845, quad
core, 2 MB cache, 1.91GHz, 10W, 2ch DDR3L)
4GB ECC, 16GB eMMC
3.7 W
3.2 W
13.2 W
13.5 W
C10M-BT-0026 (Celeron
TM
N2930, quad core,
1.83 / 2.16 GHz, 2 MB cache, 7.5W, 2ch DDR3L)
4GB non ECC
3.2 W
2.9 W
11.9 W
13.5 W
1)
1)
B
urst
2.6.2 Power Dissipation (Standby Modes)
1. System is shut down into “Soft Off” (S5) or “Suspend to Disk” (S4) by Windows 7
Professional 64-bit SP1.
2.
System is shut down into “Soft Off” (S5) or “Suspend to Disk” (S4) by Windows 7
Professional 64-bit SP1 with Wake On LAN enabled.
