AVL Looms Jacq3G, User Manual

Page: 93 / 176

Jacq3G Loom User’s Manual
Overhead Multi-Box Flyshuttle Beater (optional equipment)
Figure 69 - String tie-up and handle
7) There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
8) Slide the picker into the slots on the top of the flyshuttle box. The
leather loop should be down and to the outside.
9) Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
sure the cord goes over the top of the snubber. The snubber is a
small, round plastic piece above the shuttle box.
10) Repeat for the other side making sure that the picker loop is down
and toward the outside.
O
VERHEAD
M
ULTI
-
(
OPTIONAL EQUIPMENT
The following section applies to both the two
flyshuttle. You will find instructions for completing each assembly later in
this chapter.
Add the Pulley Assembly
1) Position the pulley support and wedge at the pre
harness pulley support. Place them together so that the pulleys and
the thick edge of the wedge face the rear of the loom.
2) Use the two #10 x 1" pan head screws to attach the upper pulley
assembly to the bottom front of your harness pulley support.
Box Flyshuttle Beater (optional equipment)
up and handle
There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
he picker into the slots on the top of the flyshuttle box. The
leather loop should be down and to the outside.
Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
ord goes over the top of the snubber. The snubber is a
small, round plastic piece above the shuttle box.
Repeat for the other side making sure that the picker loop is down
and toward the outside.
-B
OX
F
LYSHUTTLE
B
EATER
EQUIPMENT
)
e following section applies to both the two-box flyshuttle and the four
flyshuttle. You will find instructions for completing each assembly later in
Add the Pulley Assembly
Position the pulley support and wedge at the pre-drilled holes i
harness pulley support. Place them together so that the pulleys and
the thick edge of the wedge face the rear of the loom.
Use the two #10 x 1" pan head screws to attach the upper pulley
bottom front of your harness pulley support.
Install the Beater
Page | 85
There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
he picker into the slots on the top of the flyshuttle box. The
Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
ord goes over the top of the snubber. The snubber is a
Repeat for the other side making sure that the picker loop is down
box flyshuttle and the four-box
flyshuttle. You will find instructions for completing each assembly later in
drilled holes in the
harness pulley support. Place them together so that the pulleys and
Use the two #10 x 1" pan head screws to attach the upper pulley
bottom front of your harness pulley support.