AVL Looms Jacq3G, User Manual

Page: 37 / 176

Jacq3G Loom User’s Manual Assembling the Loom
Add the Data Cable Guide Page | 29
bolt through the matching hole in the Module Frame and secure
with lock washer and hex nut.
A
DD THE
D
ATA
C
ABLE
G
UIDE
1) Rest the Data Cable Guide across the back of the loom, with each
end supported by the Right and Left Top Horizontals (3R and 3L).
2) Align the holes drilled at each end of the Data Cable Guide with the
third hole from the back, on the top edge of the Right and Left Top
Horizontals (3R and 3L).
3) Hold it in place with two (2) 5/ 6 x 5” hex bolts with flat washers,
inserted from the underside of the Top Horizontals.
4) Secure each with a second flat washer, a lock washer and 3/8” hex
nut.
A
DD THE
L
OWER
B
ACK
1) Using four (4) 5/ 16” x 3- 1/4” hex bolts, with washers, attach the
Lower Back (6) between the side frames. Remember, the nut
access holes face the inside of the loom.
2) Secure the bolts with the nuts lightly.
Note:
Remember not to tighten the bolts on the frame until you have squared and
leveled the loom.
I
NSTALL THE
M
ODULES
The modules are installed at this point so that you will have enough room to
work with them.
Note:
It is best to start hanging the modules from one side of the loom and work
your way across rather than trying to work from the center out. Also, when
installing the modules make sure the electrical and data cord connections go
towards the back of the loom.
1) Rotate the Main Drive Axle towards the back of the loom, so the
Drive Shaft Stop is resting at the Rear Adjustable Stop Bracket.