AVL Looms Jacq3G, User Manual

Page: 32 / 176

Assembling the Loom Jacq3G Loom User’s Manual
Page | 24 Assembly of the Module Frame
Hardware
Hardware Location
8 - 3/8-16 x 1-1/2” Socket Head
Assemblies Cap Screws (SHCS) Side Frame Bars to Upper and Lower
8 - 5/16” x 7-1/2” Hex Bolts Right and Left Wooden Frames to
Module Frame
8 - Black Plastic Spacers Standoffs between Wood and
Modular Frames
Module Frame Assembly
1) Locate the Module Frame hardware package.
2) Locate the Lower Dial-a-Sett (D-A-S) Assembly. Position this
assembly, so that the four rubber feet are pointing up, the circular
DAS handle will be at the right side, and the bar upon which is it
resting is about 6” in front of the foremost position line for the
Module Frame.
3) Locate the Upper Drive Axle Assembly. This large and very heavy
Assembly will be comprised of the sprocket, main drive axle with
large pulleys, support bracket, vertical supports, and upper channel
supports. It can rest safely on its horizontal supports for now, with
the axle on top. Position this assembly about one foot in front of the
Lower Assembly; oriented so that the large sprocket gear is to the
left and the smaller circular DAS handle is to the right.
Figure 18 - Initial Assembly Layout
4) Locate the four wooden blocks that were packed with these two
assemblies. Note that each block, standing on its short end, will fit
neatly at the side of the assembly vertical supports. Place one at
each outer corner of this layout.