AVL Looms Jacq3G, User Manual

Page: 79 / 176

Jacq3G Loom User’s Manual
Bottom Swing Beater
2) Find the following hardware:
a. Screweye
b. two 5/16" x 2
3) Place a flystring support on th
frame piece. Insert a 5/16" x 2
of the top horizontal directly above the beater assembly. Attach a
washer and hex nut and tighten.
4) Repeat this on the other side. These supports shou
from the top horizontal with the screweye end on the bottom.
Tighten the supports securely.
5) Take the screweye from the hardware package and screw it into the
center hole on the underside of the front harness pulley support so
that no screw thr
6) The handle has a screweye at the top and one at each side
cords attached. There is a clip attached to the
handle. Attach this clip to the screweye on the front harness pulley
support.
Figure 55 - String tie-up and handle
7) There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
8) Slide the picker into
leather loop should be down and to the outside.
9) Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
sure the cord goes over
small, round plastic piece above the shuttle box.
Find the following hardware:
two 5/16" x 2-1/4" carriage bolts
Place a flystring support on the inside face of a top horizontal side
frame piece. Insert a 5/16" x 2-1/4" carriage bolt from the outside
of the top horizontal directly above the beater assembly. Attach a
washer and hex nut and tighten.
Repeat this on the other side. These supports should hang down
from the top horizontal with the screweye end on the bottom.
Tighten the supports securely.
Take the screweye from the hardware package and screw it into the
center hole on the underside of the front harness pulley support so
that no screw threads are showing.
The handle has a screweye at the top and one at each side
. There is a clip attached to the cord at the top of the
handle. Attach this clip to the screweye on the front harness pulley
up and handle
There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
Slide the picker into the slots on the top of one flyshuttle box. The
leather loop should be down and to the outside.
Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
sure the cord goes over the top of the snubber. The snubber is a
small, round plastic piece above the shuttle box.
Install the Beater
Page | 71
e inside face of a top horizontal side
1/4" carriage bolt from the outside
of the top horizontal directly above the beater assembly. Attach a
ld hang down
from the top horizontal with the screweye end on the bottom.
Take the screweye from the hardware package and screw it into the
center hole on the underside of the front harness pulley support so
The handle has a screweye at the top and one at each side with
at the top of the
handle. Attach this clip to the screweye on the front harness pulley
There are two pickers hanging below the handle. These are wooden
pieces which have a leather loop and cord attached. Take one of
these and place it so that the leather loop is toward the bottom.
flyshuttle box. The
Attach the clip at the end of the cord coming from the picker to the
screweye on the flystring supports that you just installed. Make
the top of the snubber. The snubber is a