© 2001 Directed Electronics, Inc. Vista, CA
19
transmitter/receiver learn routine
™
Transmitters are taught to the system using the Learn Routine. This system will learn up to four transmitters.
Both transmitters are factory programmed using
for arm/panic on;
for disarm/panic off/Channel Two;
and Buttons
and
together operate Channel Three. This configuration can be changed or new remotes
can be added to the system using the Learn Routine.
1.
Key.
Turn the ignition to the run position. (The YELLOW H1/9 wire must be already be con-
nected.)
2.
Valet
®
/Program switch.
Press and release the Valet
®
/Program switch the correct number of
times corresponding to the desired channel number (see chart below). Then press the
Valet/Program switch once more and
HOLD
it. The LED will blink to indicate the selected
channel and the horn will honk (if connected).
Do not
release the Valet/Program switch.
Pressing the Valet/Program Switch five times will delete all transmitters that are pro-
grammed into the system and will also change the operating settings back to the default
settings (see
Operating Settings Learn Routine
section of this guide). To use this option, select
Channel 5 (LED will blink five times) then transmit from any button of a known remote.
3.
Transmit.
While
HOLDING
the Valet®/Program switch, press the button on the transmit-
ter that you would like to control the selected receiver channel. One honk will confirm that
the code has been learned.
NOTE:
For Channel 4, press
to program the Auto Learn Standard Configuration on the two-
button transmitter.
CHANNEL
PRESS AND RELEASE
NUMBER
THE VALET/PROGRAM SWITCH
TO PROGRAM FUNCTION
1
One time
Arm/Panic
2
Two times
Disarm/Channel 2
3
Three times
Channel 3
4
Four times
Auto Learn Standard Configuration*
5
Five times
Delete all transmitters
*
NOTE:
For the Auto Learn Standard Configuration, see the Transmitter Configuration
section of this guide.
