© 2001 Directed Electronics, Inc. Vista, CA
21
operating settings learn routine
™
Many of the operating settings of this unit are programmable. They can be changed whenever necessary through
the operating settings learn routine.
1.
Key.
Turn the ignition on and then back off. (The H1/9 YELLOW switched ignition input
must be connected.)
2.
Choose.
Within 10 seconds, press and release the Valet/Program switch the number of
times corresponding to the feature number you want to program (see the
Features Menu
section of this guide). The LED ON settings listed in the
Features Menu
table are the factory
default settings.
Once the Valet/Program switch has been pressed and released the number of times corre-
sponding to the feature you wish to program, press it once more and
HOLD
it. After a
second, the LED will flash to indicate which feature you have accessed. For example, groups
of five flashes would indicate access to Feature 5. The horn will also honk five times (if
connected).
3.
Transmit.
While holding the Valet/Program switch, you can select the desired feature set-
tings using the remote transmitter. As shipped, the unit is configured to the default LED
ON settings. Pressing
while holding down the Valet/Program switch will program the
feature to the LED ON setting. The LED will light solid (stop flashing) to indicate the
setting. The horn will honk once (if connected). Pressing
while holding down the
Valet/Program switch will change the setting to the LED OFF setting. The LED will turn off
indicating the change and the horn will honk twice (if connected).
4.
Release.
The Valet
®
/Program switch can now be released.
For example, to program Feature 1 from ON to OFF, within 10 seconds of turning the ignition off, press and release
the Valet/Program switch once. Then press it again and
HOLD
it. The LED will flash in groups of one and the horn
will honk once (if connected). While holding the Valet/Program switch, press
on the transmitter. The LED
will stop flashing and go out. The horn will honk twice if connected. The ignition-controlled door locks feature
has now been programmed off. If this is not the desired setting, without releasing the Valet/Program switch,
press
on the transmitter. The LED will light solid and the horn will honk once if connected. The ignition-con-
trolled door locks feature has now programmed on. Release the Valet/Program switch after the desired selection
has been made.
