ADDITIONAL INFORMATION FOR PROGRAMMING THE MRL DCP
SMS COMMANDS
+
All MRL DCP parameters can be remotely configured via an SMS sent to the SIM card’s number
+
Each SMS message should begin with ‘Pin1234’ which is the access code to read or make any changes to the
configuration of the MRL DCP
+
You can modify or check several parameters in each SMS by separating them with commas ","
To send parameter information:
Pin1234, Pxxx then value to set, (send)
To read parameter information:
Pin1234, Pxxx? (send)
Note: Use a question mark ‘?’ when you are reading parameters.
Examples:
1.
To program telephone number 1 in the MRL DCP when connected to a DAU
E.g. Pin1234, P031 0123456789 (send, text message will come back with P031=0123456789)
2.
To retrieve telephone number 1 in the MRL DCP when connected to a DAU
E.g. Pin1234, P031? (send, text message will come back with P031= or with the programmed number)
Note: To reset your unit to default settings the following parameters are important.
CMD
Description
Default value
P005
CCID- Unique Identifier of the Sim Card
(19 digits)
P020
MRL DCP Background Call Mode
P020=00 -> Memtel Protocol
P020=06 -> CAN Protocol
P020=21 -> P100 Protocol
21 (Autodiallers need to make
Background calls in P100
Protocol)
P064
Background Call Periodicity (in Minutes)
4320 (3 days)
P031
Alarm Number 1
(Blank – Insert your alarm
number here)
P032
Alarm Number 2
(Blank)
P033
Alarm Number 3
(Blank)
P034
Alarm Number 4
(Blank)
P035
Background Number (not used with DAU)
3308084431 (must match
Background Number in
Autodialler, without prefixes)
P008
Enable Guidance Message *
0 (disabled)
P085
Language
4 (English)
P091
Super settings set up
000
P003
MRL DCP information (software version, type of DCP)
As per package
Important Note: The default PIN code for DCP is 1234.
10
