+
Once finished return SW1 dipswitch 1 back to OFF.
7.
If a non-Avire SIM card is used, APN settings must be set prior to configuring it
on the Avire Hub (please refer to “Setting Parameters on non-Avire SIM cards” on
page 3). If the SIM LED is red, please refer to “SIM Card unlocking” on page 3.
8.
Once the device is set-up and connected, please add it to the Avire Hub online
platform for elevator and device monitoring options (http://hub.avire-global.com/).
Please use the “Help” section for tutorials on how to use the Avire Hub.
2
6.
If required, connect additional products to the CANBus via J7 (pin1= Gnd, pin2= CAN L,
pin3= CAN H, pin4= Vcc)
*Please refer to pages 11 and 12 for the full picture and connector information
J7*
5.
Check the signal strength by using the built-in network
signal strength scanner. To use this function:
+
Turn SW1 dipswitch 1 to ON (check dipswitch 4 is also ON)
+
LEDs on the front of the DCP unit will show the network
signal level
SW1*
