CDM Assembly
T1689 Technical Manual Rev 07
Introduction
MV3000 Air Cooled DELTA
Page 110
5.1.1
Recommended Order of Assembly
It is recommended that the drive assembly order shown below is followed:
a)
Fit floor mounted reactors (interbridge transformer / d.c. link reactor, line reactor).
b)
Fit DELTA mounting rails and other internal metalwork.
c)
Fit a.c. sharing reactors.
d)
Install Fan assembly.
e)
Install DELTA power modules.
f)
Install control components.
g)
Connect high power cables or busbars.
h)
Fit DELTA power module shrouds and earth bonding plates.
i)
Fit SMPS modules.
j)
Connect control cabling.
k)
Fit overall enclosure shrouds
NOTE:
Some of the steps listed above may not be required, depending upon individual system configuration.
Before starting any assembly work, reference should be made to Sections 2, and 3 of this manual.
Section 2: Specification gives details of individual components of the DELTA product range.
Section 3: Drive (CDM) Design includes details about preparation and planning for assembly, and guidance for
design of the cooling circuit.
NOTE:
References in this section to 'left' and 'right' should be taken to mean the viewer's left and right when facing
the front of a module.
