E6L Engine AVB-192 Network Card Replacement
7
9
If your engine only has a single AVB card and no other cards above it, use a #2 Phillips screwdriver to reinstall any captive rear
mounting brackets you removed earlier, or move them back into position, and tighten them.
10
Re-connect the red and black power cable to the AVB-192 card.
11
Re-connect the Ethernet cable from the E6L to the right-most port on the Master AVB-192 card.
12
If your E6L-192 or E6L-144 also has a WSG-HD card, re-connect the jumper cable between the far left port on the edge of the
AVB-192 card to the far left port on the WSG-HD card.
13
If your E6L only has a single AVB-192 Network Card, proceed to
Re-install the E6L Engine Core
.
14
If your E6L has two AVB-192 Network Cards, re-install the second card as explained in the following instructions.
Figure 16. Master AVB-192 power cable reconnected (note cable routed below the Master AVB card)
Original factory cabling may vary. Follow the instructions in this guide to achieve the recommended cabling scheme.
Figure 17. Ethernet connection from WSG-HD to Master AVB-192 (E6L-192 or E6L-144 only)
Cable colors shown might not match the cables in your E6L.
