E6L Engine AVB-192 Network Card Replacement
11
Re-Installing the WSG-HD or MADI-192 #2 Card (E6L-112 Only)
You can install either a WSG-HD card
or
a
second
MADI-192 card in AVB Network slot 3 of an E6L-112 engine. You cannot have
both a WSG-HD card and a second MADI-192 card installed simultaneously in an E6L-112. In addition, you cannot install any
MADI-192 card into Network slot 3 if there is not a MADI-192 card installed in Option card slot 6 of the E6L-112 engine. For more
information see the
MADI-192 MADI Option Card Guide.pdf
.
To re-install a WSG-HD or second MADI-192 card into AVB Network slot 3 in an E6L-112 (only):
1
If necessary, re-install or move back into position the captive rear bracket for slot 3.
2
Hold the card it by its edges.
3
Inside the unit, place the face of the card into position in the slot, with the back of the card tilting upwards.
4
Using two hands, hold the front of the card in place in the slot with one hand, and slowly move the back of the card downwards
along the sheet metal until the card is horizontal.
5
Once the card is horizontal, make sure the tab on the right side of the faceplate is outside of the E6L chassis slot.
6
Align the PCIe connector on the card with the corresponding PCIe port, and align the flange on the card with the retaining clip
on the PC board.
7
Lift the tab on the retaining clip, and then press the card firmly into the PCIe port and clip.
8
When the card is properly seated in the slot, tighten the exterior captive thumbscrew to secure the faceplate of the card to the
back panel of the E6L.
9
If you replaced a MADI-192 card, proceed to
Re-install the E6L Engine Core
. For WSG-HD, proceed to step 9.
10
Tighten the rear bracket captive thumbscrew to secure the back of the WSG-HD card to the back bracket.
11
WSG-HD Only: Using the Ethernet jumper cable, connect the far left port on the edge of the Master AVB-192 (in the Master
AVB Network slot 1) to the far left port on the WSG-HD card.
Figure 26. Lifting the tab on the retaining clip
Figure 27. Securing the card to the back bracket
Figure 28. Ethernet connection from WSG-HD to Master AVB-192 (E6L-112 only, 1x AVB-192 card shown)
