AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
9
Secure the wings :
Fit the wing joiner tube through the fuselage.
Install the left and right booms .
Take care to put it at the center (same lenght left and
right ).
Install the left and right wings.
A plywood reinforcement is located between the fiber
tube and the wing skin to drill the hole to secure the
wings.
You can see it from the flap servo hole or from the
wing root (if it is open). It is located at 23 cm from the
wing root under the wing
Make a 2.5 mm hole at 230 mm from the wing root throught the wing and aluminium tube to secure
the wings
Threated the wing tube and wing at M3 mm and secure wings with a M3x30 screw
You can also secure the tube in the fuselage.
Make a 2.8 mm hole in the center of the fuselage from
the gear door. Drill the hole throught the plywood frame
and aluminium tube to secure the tube.
Screw a 3 x 16 mm parker screw through the plywood
and aluminium tube, so the tube will not move during
assembling and desassembling.
If you don’t secure the tube in fuslage, write with a pen
on the tube the fuselage location for an easier
assembling and to find the hole to secure the wings
Secure the horizontal stabilisator :
Install the stab between the 2 booms.
Secure the stab with 4 x M6x40 nylon screws
