AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
7
Aileron and flaps servos :
Process as the stab servo :
Increase the hole for the servo location in the wings with a
permagrit rotating tool for the aileron and flaps
Screw the servo in the servo cover (you can also glue it
with silicon glue for more security)
Put in place the
servo cover on the
wings
Drill 4 x 1 mm hole
in the wings for the
screws
Cut a slot in the control surface for the fiber control horn
Glue with fast epoxy the control horn
Connect two 3 mm link with M3 threaded rod
Screw the servo cover with the 4 parker screws
Connect the servo with the control horn
Apply thread
lock.
Make a 5 mm hole in the wing root for the servo electric wire
Don’t make the hole too big so that the conector can’t fall in the
wing
Sold electric wire for the flaps and aileron
Flaps control horn
Aileron control horn
